Since 1990 Bill's Hot Rod Co. Has had one goal in mind; to design alternator, air conditioner and power steering brackets that fit and are easy to use, as well as affordable and stylish. The 100 Series alternator brackets fit GM 10-SI or 12-Si alternators. Brackets position the units on top of the engine, keeping them close to the middle and as low as possible.
Brackets come completely assembled with all stainless steel bolts and washers, illustrated instruction sheet, and belt size recommendations with adjusting tips. Alternator Bracket / Passenger side. Fits late Small Block Chevy Vortec Cast Iron Heads w/ short water pump application.
Fits GM 10-Si or 12-Si alternator. 1/4 mild steel plate is used for strength and durability. 100 Series SBC Vortec Alternator Bracket, Chrome. No drilling or tapping necessary. Choose between black, chrome, and raw finishes. To protect and preserve the finish on these powdercoated or chrome plated brackets, be sure to apply a good quality such as carnauba, as needed. Bracket mounts using only the existing factory drilled holes found on the front face of the heads.Some minor grinding or filing on the manifold may be necessary. This part worked perfect on SBC Vortec, clear tall covers. By Gary on May 12, 2020. Used on a Model A Coupe with a Deuce grille, now I can use my hood.
Yes, I recommend this product. Speedway Motors is America's Oldest Speed Shop® and has been a trusted source for specialty rodding and racing products and friendly expert advice for more than 71 years.